|
 |
 |
 |
 |
|
|
|
|
|
|
 |
|
||||||
| To request literature, please e-mail us at info@LogicSeal.com | ||||||||
Leading the way in negative pressure |
||
|
||
| The original leak stopper | ||
| The
Logic Seal and Vac-U-Temp do more than just prevent leaks in your mold. They are part of a
system designed to increase the productivity of your molding. Many of your venting and cooling problems will disappear. SAFER OPERATIONS- Our units can be set for little or no positive pressure, which minimizes painful and costly accidents. |
||
| Vac-U-Temp(tm) | ||
|
|
||
THE ORIGINAL COMBINATION MOLD HEATER AND LEAKSTOPPER - IT DOESN'T JUST PREVENT LEAKS IN INJECTION MOLDS - IT'S PART OF A COMPLETE SYSTEM DESIGNED TO INCREASE THE PRODUCTIVITY OF YOUR MOLDS! |
||
| With the Vac-U-Temptm System not only are water leaks a thing of the past, but so are many of your venting and cooling headaches as well. Only genuine Logic Corporation products may be used with Water Transfertm, Waterline Ventingtm, or other negative-pressure techniques that will vastly increase your production rate. | ||
| Cluster Valves & Manifolds(tm) | ||
IT'S ONLY LOGICAL... THAT LOGIC CORPORATION WOULD INVENT THE MANIFOLD THAT CAN DO WHAT NO CONVENTIONAL MANIFOLD CAN .... PROVIDE EQUAL PRESSURE DROP ON ALL PAIRS OF PORTS. |
|
|
| Now you don't have to buy two manifolds
- one for supply, and one for return when you really only want one. All you need is one 2 x 4 Single Point Control" (SPC) Manifold from Logic Corporation. (Or a 2 x 6, or a 2 x 8.) The SPC is the ONLY manifold that is complete with both supply and return built together as one integral unit. And, because the supply and return to and from the manifold are opposite each other, all pairs of circuits have the same pressure drop - Guaranteed! Conventional manifolds have different pressure drops on each pair of ports - if the mold circuits are not connected to exactly the same pairs of ports that they were the last time it ran, the pressure drop will be different on that circuit, hence the flow rate, hence the cooling rate will be different. The SPC Manifold eliminates that variable. And that will help your Statistical Process Control program - the "other" SPC, to help your bottom line. And if those aren't enough reasons to have the SPC Manifold, then just click the link below for more info! |
||
| [ Home ] [ About Us ] [ Products ] [ Consulting ] [ Representatives ] |
Copyright 1998,1999 Logic Corp. All rights reserved. Click for detailed Copyright information. Last changed 11/21/07
