Logic Corp - Improved molding efficiency

 


Articles
Read articles about water transfer, venting and other topics of interest.

Testimonials
See what customers think about our products and customer service. Want to have your testimonial posted? Email us at logic@logicseal.com


Specials & Discounts

Discounted Units & Special Deals.
 

 


Phone: (203) 598-3400
Toll Free: (800) 325-6442

Fax: (203) 598-3401
email: Info@logicseal.com
Inventor of the Logic Seal

CONDENSED EQUIPMENT SPECIFICATIONS

MODEL VT-3000 Vac-U-Temp

  •  50 gpm, Closed-loop Negative Pressure System, 1.5 HP Pump
  •  Digital Dual Readout Temperature Controller
  •  Circuit Breaker on Incoming Power
  •  Motor Starter Relay
  •  Electronic Overload Protection on Motor
  •  Pump Reversal Protection with Indicator Light (Phase Monitor)
  •  Avail.Voltages:208-240/8 Amps, 460-480/4 Amps(120 volt control circuit) 
  •  All Electrical Components are UL/CE Rated
  •  Pre-vac Switch(to prevent unwanted pressure to the mold before start-up)
  •  Liquid Filled Gauges: TO MOLD, FROM MOLD, COOLING SUPPLY, AIR SUPPLY
  •  Copper and Bronze Plumbing
  •  An estimated 5 Gallon Stainless Steel Reservoir Tank
  •  Automatic Filling (filling and maintaining fluid level)
  •  Low Watt density Heaters (300°F w/approved Heat Transfer Fluids) 
  •  Logic’s Air Separation & Removal System with Indicator Lights
  •  3.2 Sq. Ft. Heat Exchanger
  •  Powder Coated, Ventilated Steel Cabinet
  •  Bonded Rubber Casters
  •  Post sizes: 1-1/4” NPT: TO MOLD and FROM MOLD,
    3/4" NPT: AIR/RESERVOIR/COOLING SUPPLY and COOLING RETURN


CABINET: L: 14" W: 24" H: 33"  WEIGHT:  280 lbs.

Approximate Ship Weight: 225 lbs
Ship Size / Skid : 30"L x 40"W x 39"H
Ship: Class 70, Freight Carrier Do Not Stack
NMFC#133300

Specifications subject to change without notice. "Vac-U-Temp" is a trademark of Logic Corporation. The Vac-U-Temp temperature controller/leakstopper U.S.Patent #4,287,941.

© 2009 All rights reserved. Logic. Copyright information